6 flute square end mill with special angle ground for workpiece up to HRC70. VMG Special Micro Grain Carbide features high hardness, high rigidity, and high bending resistance. i-plus new coating offers great heat resistance and friction resistance. Suitable for dry cutting at high speed.<br/>
            

HGT Solid Carbide Square End Mill - 6 Flute - V70E Diameter 6.0mm~16.0mm 

V70E

4 flute square end mill for Stainless Steel, Titanium & Ti alloys, and High temp. alloy. Variable helix angle and unequal flute spacing offer great stability and anti-vibration. G-plus Coating enables higher efficiency and longer tool life.<br/>
            

HGT Solid Carbide Square End Mill - 4 Flute - SIW Diameter 3.0mm~20.0mm  

4 flute ball nose end mill for Graphite. CVD Diamond Coating maximizes abrasion resistance and extends tool life. GMG Carbide material features excellent anti-vibration; a great match for CVD Diamond Coating.          

HGT Solid Carbide Ball Nose End Mill - 4 Flute - SGBB Radius R2mm~R6mm 

SGBB

Combination of carbide and stainless steel: Greater anti-vibration and wear resistance. i8 Coating: High temperature resistance and low wear. Dry and wet cutting. Exchangeable Carbide End Mill system. Replace the end mill head when the tip is worn out. 
            

HGT Solid Carbide Corner Radius End Mill Head for use with HGT Carbide Holder - 4 Flute - EX2SRD Diameter 10.0mm~20.0mm 

EX2SRD

New cutting edge better than old design to improve chip removal. Straight coolant holes to lower down the heat and for better chip flow.  